Product Code(SKU): S01RLPDQSH
Product Category: Tools & Home Improvement
Product Category: Home Improvement
Product weight: 12.97 Pounds
Brand: Konmison
Feature:
Dimensions: 250 * 250 * 270MM (9.8 * 9.8 * 10.6 )
Working Area 130 * 100 * 40mm (5.1 * 3.9 * 1.6 )
Carving stroke: 130 * 100MM (5.1 * 3.9 )
Screw: M6 threaded rod (4 mm or screw T8)
Stepper motor: nema 17
Voltage: 24V5A switching power supply and two 12V5A; 4000rpm, 12v; 7000rpm, 24v.
Spindle: 42MM (1.7 ) diameter, 775 motor
Package inclued:
1x engraving machine (All parts of the mechanical parts)
Attention:
First, in these assembly units, axle X is horizontal axis of the upright; axle Y is the pedestal; axle Z is the vertical direction. Depends on your habit to set the positive and the negative direction.
Second, If these three axles adjust bad, they will be stuck or not smooth, in this situation, you should loosen the screws and push it until they are smooth, and then you should tighten it.
Third, if the tail of the lead screw swing, it s not the lead screw is crooked, but the motor shaft of the lead screw and the lead screw are not adjusting in the same line.
Fourth, ARDUINO UNO (blue), doesn t need to connect the power, and it is prohibit connect 24V power.
