Product Code(SKU): S07P24SG1G
Product Category: Automotive
Product Category: Automotive Parts and Accessories
Product weight: 1.40 Pounds
Brand: VTOLO
Did you just find a dent in your car after parking in a garage? Or did you get into a fender-bender and now your flawless car has a number of creases? May it be an accidental bump or dent caused by foreign objects, spare yourself the stress and let this repair kit do the job for you. Save time and cash as you witness these tabs restore your car s allure like it s never been damaged before.
There important Tips:
1.Clean the area to be repaired with 91% isopropyl rubbing alcohol and a clean towel. It is important to remove all wax and grease from the surface to insure the glue and dent pulling tabs properly adhere to the damaged area.
2.Apply the glue pulling tab to the exact center of the dent. Avoid applying too much pressure when placing the dent pulling tab to the dented area, so you do not create too thin of a layer of glue between the car panel and the pulling tab.
3.Allow the glue to set for about 5 minutes prior to using any glue pulling tool. The glue should be hard to the touch at the time you begin repair. If your fingernail leaves an impression in glue, simply allow a couple more minutes for glue to harden. Keep the panel to be repaired out of the direct sunlight so the glue will set properly.
4.It is common for the dent pulling tab to release from the glue, leaving the glue on the panel of the vehicle. When this occurs, spray 91% rubbing alcohol on the edge of the glue and peel it away using the plastic scraper.
5.You may need to repeat steps until the desired result is achieved. It is not uncommon to repeat the process up to ten times.
Packing List
1.1xMelt Dent bridge
2.10xDifferent size pulling tabs
3.1xDent Puller Suction Cup, 2"Inch
4. 1xPlastic scraper
5. 4xYellow hot melt glue sticks
6. 1x 100W hot melt glue gun